Installing a garage door and taking out the old door is not a project for the beginning do-it-yourselfer. The doors are heavy and handling the torsion springs can be unsafe. Garage doors can differ greatly in the difficulty of installation. It would be best to go to store that caters to do-it-yourselfers to pick out a door.

Rowlett Garage Door
Rowlett Garage Door

If you are a skilled home handy-person, then you should give this plan a try. Although, you should do your thorough research before starting your project. Rowlett Garage Door companies have responded to the DIY market by creating lighter doors with lighter torsion springs. Inquire at your home builder’s store of the more DIY-friendly garage door kits.

Tip 1 – Clearing out the Garage

Make sure you have a perfect safe working space in the garage and the top of the driveway before you begin. Remove the cars. Make sure that everything is safe on the walls of the garage. Make sure there isn’t anything on the garage floor for you to trip over or get wrecked by falling pieces.

Tip 2 – Removing the Old Door

Especially if the old garage door has a typical torsion spring, you should not try to get rid of the old door yourself. The spring can be like a weapon and may be a reason of serious injury to someone who does not know what they are up to. For this part, it is best to appoint the help of a proficient individual. A handyman with knowledge removing old garage doors would be the most reasonable option.

Tip 3 – Inspecting and Preparing the Garage Door Frame

Once the old door is removed, you can then check for any rotting in the frame and replace wood accordingly. Now you are prepared to install the new door. It is important that the new door be connected in a solid and square frame. So take your time to check the door frame properly, using squares and levels. You may have to redo garage door frame.

Tip 4 – Studying the Layout of the Door Pieces

Make sure you totally apprehend the instruction diagram before starting. Lay out all the pieces in a simulation of how they will be organized when full assembled.

Tip 5 – Hardware and Fastening

The garage door is a very important part of your house. It secures your home and your car, and children spend a lot of time playing near garage doors. Only buy hardware approved by the manufacturer. Use all new hardware. Every fastener should be close-fitting, but be cautious not to strip anything. A fully assembled door can weigh over 400 pounds. You don’t want it falling to your car or any person.

Tip 6 – Preparing for Assembly

Make sure you track the instruction manual very cautiously while gathering the various parts.

Tip 7 – Leveling the First Section

The garage door is the main mechanical device in your house, so take your time with this project. It is very significant that the first section you install be level, or the sections will get even more out of level as you pile them up.

Tip 8 – Setting the Weather-stripping

Once the bottom section is installed, the weather-stripping can be set in place with nails.

Tip 9 – Spring Adjustment

The spring is the heart of the door process and security. Be particularly mindful when reading the instructions for adjusting the door springs. The door should be flawlessly balanced when halfway open, if the spring is properly adjusted. It should not want to close or open in the half-way position.

Tip 10 – Final Assembly and Inspection

Check all the sub-assemblies in contradiction of the diagrams in the book. Make sure the whole thing is snug and there are no extra parts sitting on the floor or driveway. The door must  have a smooth glide. Check everything for level and straightness.